Smoke Alarm Types in NZ: Which to Choose for Your Home

For most New Zealand homes the answer is interconnected, long-life photoelectric smoke alarms. Fire and Emergency New Zealand (FENZ) recommends photoelectric alarms because they are far better at detecting slow-smouldering fires, and it recommends linking them so one alarm sets off every alarm in the house. Hard-wired mains alarms are the best option, and they need an electrician. If you are renovating, that work can be planned into the job and covered by the consent, which is how we handle it at Sorted Home Solutions.
This guide explains the types, how to compare them, where they go, and how to look after them.
TL;DR
Choose photoelectric alarms. FENZ recommends installing only this type, and Consumer NZ reports ionisation alarms have been removed from sale in NZ.
Interconnect them (wired or wireless) so an alarm in one room sounds throughout the home.
Power: hard-wired 240V mains with backup battery is the top option. If you choose battery alarms, pick sealed 10-year units.
Put alarms in bedrooms, living areas, hallways and landings, with at least one on every level. Use a heat alarm or a kitchen-rated alarm near the kitchen.
Test monthly, and replace the whole alarm at 10 years or at its expiry date.
Table of Contents
The two sensor types: photoelectric and ionisation
Every smoke alarm uses one of two sensing methods, and the difference matters more than brand or price.
Photoelectric alarms have a small chamber with a light beam. Health New Zealand explains that they sound when smoke changes the light levels in that chamber. They respond well to smouldering fires, such as a cigarette in a couch or an overheated cord, and to flaming fires. Consumer NZ’s March 2024 buying guide says they detect both flaming and smouldering fires effectively.
Ionisation alarms detect smoke when particles block a small electrical current of ions in the chamber. Health New Zealand notes they contain a very small amount of americium-241 sealed inside a metal chamber, and says radiation exposure from the alarm is very small. It still recommends photoelectric alarms for household installation.

If you have just bought an older house, check what is already on the ceiling. Consumer NZ advises replacing any remaining ionisation alarm with a photoelectric one. FENZ says photoelectric alarms are far more effective at detecting slow-smouldering fires, which are the fires that often start at night while people sleep.
What about dual-sensor and smart alarms?
Some products combine both sensors, and others add app notifications or voice alerts. Because FENZ recommends installing only photoelectric alarms, the sensor is the feature to settle first. Extras such as a phone alert are optional on top of a photoelectric, interconnected alarm and never a replacement for one.
Heat alarms and carbon monoxide alarms
A heat alarm reacts to a rise in temperature, not to smoke. That makes it suited to places where steam, cooking fumes or dust would set off a smoke alarm again and again. FENZ says heat alarms may be used in kitchens, bathrooms, laundries and garages, while photoelectric smoke alarms belong in bedrooms, living areas and hallways.
Consumer NZ is clear that heat alarms and carbon monoxide alarms are not smoke alarms and should not stand in for them, although some products combine functions. Treat them as additions for specific rooms.
Power source: mains, 10-year sealed battery or 9V battery
This is where homeowners usually make the decision, because it affects cost, wiring and upkeep.
Power type | How it works | Upkeep | Installation |
Hard-wired 240V mains | Connects to the home’s electrical supply, with a backup battery | Backup battery per the maker’s instructions | Electrician required |
Sealed 10-year lithium battery | Battery is built in and lasts about the alarm’s life | Replace the whole alarm at 10 years | Screw to the ceiling |
Replaceable 9V battery | User-changeable battery | Change at least annually | Screw to the ceiling |
The details behind the table:
Hard-wired: FENZ says hard-wired photoelectric alarms are the best option but need an electrician to install. Consumer NZ says mains alarms connect to the 240V supply and have backup batteries, which can be annual-change 9V batteries or rechargeable batteries lasting the alarm’s 10-year life.
Sealed 10-year battery: FENZ says long-life battery photoelectric alarms give up to 10 years of detection. Consumer NZ recommends this sealed type if you choose battery-powered alarms, because the battery cannot be forgotten or removed.
9V battery: Consumer NZ says these batteries typically last about a year. FENZ advises replacing them at least annually, or sooner if the alarm chirps.
For a sound alarm in a long-term home, wired or sealed 10-year photoelectric alarms are the practical options. Electrical work in a house is regulated, so any new wiring is a job for a licensed electrician. Our guide to electrical consent in NZ explains what is needed and when.
Why interconnection matters
An interconnected system links alarms so that when one detects smoke, all of them sound. FENZ recommends interconnected photoelectric alarms, by wiring or wireless connection, and highlights their value in multi-storey homes and homes with long hallways.
The reasoning is simple. A fire in a garage or downstairs living room may be a long way from a closed bedroom door. If only the nearest alarm sounds, the people asleep upstairs hear it later, or not clearly. Linked alarms give everyone the same warning at the same moment.
Two ways to link alarms:
Wired interconnection, where the alarms are connected by cable, often alongside mains power.
Wireless interconnection, where sealed 10-year battery alarms talk to each other by radio. This suits homes where running cable through finished walls and ceilings would be disruptive.
Where to put alarms
FENZ recommends photoelectric alarms in bedrooms, living areas and hallways, installed in the middle of each room’s ceiling. In a multi-level home, put at least one on each level.
The kitchen needs thought. The National Planning Data Centre says a kitchen or scullery separated from living spaces and hallways by closable doors needs an alarm specified by its manufacturer as suitable for a kitchen, which may be a heat alarm to reduce nuisance activations. If you are planning a new kitchen layout, alarm positions are best decided at the same time as the ventilation. Our guide to kitchen ventilation requirements covers the extraction side, and our article on smoke alarm placement and renovation timing covers the bedroom coverage rule.

Alarms for people who are Deaf or hard of hearing
FENZ says people who are Deaf or hard of hearing can use specialised systems with louder or lower-pitched sounds, flashing strobes or vibrating devices. It describes interconnected alarms with bed-shakers and/or strobes as ideal. If anyone in the home needs this, choose a compatible system at the start, so the wiring and ceiling positions suit it.
What the building rules say about new work
Since the building-code acceptable-solution changes made from November 2024, new homes and consented renovations covered by those provisions need interconnected alarms. The National Planning Data Centre says they can be wired or wireless, powered by either a sealed 10-year battery or 240V mains. The same guidance says covered alarms must be:
installed in bedrooms, living spaces, hallways and landings, with at least one on each level of a multi-level home;
on or near the ceiling;
fitted with test and hush buttons.
If your renovation needs a building consent, the alarms are part of that consent work. Check your council’s guidance for your project, and ask whoever is managing the consent to confirm what applies to your house.
For tenancies, the healthy homes changes that took effect on 25 September 2025 concerned insulation exemptions and how certain requirements take priority. The notice does not describe a change to smoke alarm requirements.
Testing, cleaning and replacing
A good alarm still fails if nobody looks after it. FENZ’s guidance is:
Press the test button regularly. Monthly testing is advised.
Clean dust and spider webs with a duster or vacuum.
Replace a 9V battery at least once a year, or sooner if the alarm chirps.
Replace the whole alarm after 10 years or by its stated expiry date.
Check the date printed on the alarm when you move into a home. Many alarms older than 10 years are still on ceilings, and there is no way to see by looking that the sensor has aged.
What the sounds mean
A continuous loud alarm means smoke or heat has been detected: get everyone out, stay out and call 111. A short, repeated chirp is normally a low-battery or fault signal, and FENZ’s advice for a chirping 9V alarm is to replace the battery. A chirp from a sealed 10-year alarm often means it is near the end of its life. Because patterns differ between models, keep the manual or check the maker’s label on the alarm.
Free help from FENZ
FENZ offers a no-cost visit from your local fire station to check that your alarms work and are in the right places, help replace batteries, install alarms if needed and help you prepare an escape plan. The number in its home fire safety guide is 0800 693 473. It is a sound first step for a first-time buyer who has just moved in.
A choice for first-time buyers
If you have just bought, a simple plan works:
Check the age and type of every alarm. Replace ionisation or out-of-date units with photoelectric.
Decide between wired and sealed 10-year wireless alarms, based on how easily a ceiling can be accessed.
Place alarms in each bedroom, living area, hallway and landing, with one on every level.
Use a heat alarm or a kitchen-rated alarm where steam or cooking would cause false alarms.
Write the replacement date on your calendar.
Our view: plan alarms into the renovation
We manage kitchens, bathrooms, electrical work, plastering and painting under one roof, so we see alarms as part of the ceiling and wiring plan and not an afterthought. The sensible moment to put in hard-wired, interconnected photoelectric alarms is when the ceilings are open or the wiring is already being touched. The electrician is on site, the plasterer follows, and the painter finishes the ceiling, all coordinated by one team with one point of contact. We also handle the building consent process, so alarm requirements sit inside the same paperwork as the rest of the job. Our advice to homeowners: pick photoelectric, pick interconnected, and decide the power type before the walls are closed up. Rudi
Work it into your renovation
If you are planning a kitchen, bathroom or full home renovation in Auckland, we coordinate all the licensed trades with fixed-fee quotes, so smoke alarm wiring and placement can be included in the scope. See our kitchen and bathroom packages or our full home renovation service.

For smaller fixes such as patching and repainting after an alarm moves, our small jobs services cover touch-up painting and patch repairs.
FAQ
Does Fire and Emergency New Zealand offer free smoke alarms?
FENZ offers a no-cost visit from a local station to check your alarms, help replace batteries and install alarms if needed. Call 0800 693 473 to ask about it. Availability depends on your local station.
Where are smoke alarms not required or not suitable?
A kitchen separated from living spaces and hallways by closable doors needs an alarm the manufacturer specifies as kitchen-suitable, which may be a heat alarm. Bathrooms, laundries and garages are places where FENZ says heat alarms may be used.
How many types of smoke alarms are there?
By sensor there are two: photoelectric and ionisation. By power there are three: hard-wired mains, sealed 10-year battery and replaceable 9V battery. Heat and carbon monoxide alarms are separate devices and do not replace smoke alarms.
What are the best smoke detectors for a New Zealand home?
FENZ recommends long-life, interconnected photoelectric alarms, and hard-wired ones are the best option. Look for test and hush buttons, a stated 10-year life and an expiry date on the alarm.
Sources
Recommended


Comments